Special Cuts - BLACK&DECKER BT1400 Manual De Instrucciones

SPECIAL CUTS

NEVER MAKE ANY CUTS UNLESS THE MATERIAL IS
SECURED ON THE TABLE AND AGAINST THE FENCE.
Aluminum Cutting (Carbide tipped blade only)
Aluminum extrusions such as those used when making
aluminum screens and storm windows can easily be cut
with your saw using the proper blade designed for non-fer-
rous metal cutting. Position the material so that you will be
cutting the thinnest cross section, as shown in Figure 9.
Figure 10 illustrates the wrong way to cut these extrusions.
Use a wax lubricant when cutting aluminum such as
Johnson's Stick Wax No.140. Apply the stick wax directly
to the saw blade before cutting. Never apply stick wax to
a moving blade.
The wax, available at most hardware stores and industrial
mill supply houses, provides proper lubrication and keeps
chips from adhering to the blade.
Be sure to properly secure work. Certain workpieces, due
to their size, shape or surface finish, may require the use of
a clamp, jig or fixture to prevent movement during the cut.
Bowed Material
When cutting bowed material always position it as shown
in Figure 11 and never like that shown in Figure 12.
Positioning the material incorrectly will cause it to pinch the
blade near the completion of the cut.
Cutting Plastic Pipe and other round cross-sectional
material
Plastic pipe can be easily cut with your saw. It should be
cut just like wood and clamped or held firmly to the fence
to keep it from rolling particularly when making angle cuts.
MAINTENANCE
(PERFORM ALL MAINTENANCE WITH MITER SAW
UNPLUGGED.)
1. All bearings are sealed. They are lubricated for life and
need no further maintenance.
2. Periodically clean all dust and wood chips from around
AND UNDER the base and the rotary table. Even
though slots are provided to allow debris to pass
through, some dust will accumulate.
3. The brushes are designed to give you several years
of use. If they ever need replacement follow the
instructions in this manual or return the tool to the
nearest service center for repair.
Important
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (including brush inspection
and replacement) should be performed by authorized
service centers or other qualified service organizations,
always using identical replacement parts.
Trouble Shooting Guide
BE SURE TO FOLLOW SAFETY RULES AND
INSTRUCTIONS
TROUBLE! SAW WILL NOT START
WHAT'S WRONG?
1. Saw not plugged in
2. Fuse blown or circuit
breaker tripped
3. Cord damaged
4. Brushes worn out
TROUBLE! SAW MAKES UNSATISFACTORY CUTS
WHAT'S WRONG?
1. Dull blade
2. Blade mounted
backwards
3. Gum or pitch on blade
4. Incorrect blade for work
being done
TROUBLE! BLADE DOES NOT COME UP TO SPEED
WHAT'S WRONG?
1. Extension cord too light
or too long
2. Low house current
TROUBLE! MACHINE VIBRATES EXCESSIVELY
WHAT'S WRONG?
1. Saw not mounted
securely
2. Stand or bench on
uneven floor
3. Damaged saw blade
31
WHAT TO DO...
1. Plug in saw
2. Replace fuse or reset
circuit breaker
3. Have cord replaced by
authorized service center
4. See "Brushes" in this
manual
WHAT TO DO...
1. Replace blade
2. Turn blade around
3. Remove blade and
clean with turpentine
and coarse steel wool
or household oven
cleaner
4. Change the blade
WHAT TO DO...
1. Replace with adequate
size cord
2. Contact your electric
company
WHAT TO DO...
1. Tighten all mounting
hardware
2. Reposition on flat level
surface
3. Replace blade