Flash Exposure Compensation; Feb - Canon MR-14EX II Manual De Instrucciones

g FEBN
You can take three shots while automatically changing the flash output.
This is called "FEB (Flash Exposure Bracketing)". The settable range is
±3 stops in 1/3-stop increments.
After the three shots are taken, FEB is canceled automatically.
Before shooting with FEB, it is recommended to set the camera's drive
mode to single shooting, and check that the flash is recycled for each shot.
You can use FEB together with flash exposure compensation or FE lock.
If the camera's exposure compensation is set to 1/2-stop increments, flash
exposure compensation will be up to ±3 stops in 1/2-stop increments.
You can set FEB to remain active after shooting the three shots (C.Fn-03/p.61).
You can change the FEB shooting sequence (C.Fn-04/p.62).
28
1 Press the <E> button.
Press function button 3 <E>.
<g> is displayed.
2
Set the FEB level.
Turn <9> to set the FEB level, then
press <8>.
The FEB level is set.
"0.3" indicates 1/3 stops and "0.7"
indicates 2/3 stops.
When used together with flash
exposure compensation, FEB
shooting is performed based on the

flash exposure compensation

amount.
When the FEB range exceeds ±3
stops, the end of the flash exposure
level shows <I> or <J>.