Stihl ADG 2 Manual De Instrucciones página 5

geometrically matching STIHL type AP
batteries with a maximum capacity of
10 Ah and a maximum voltage of 42 V.
WARNING
Do not use it for other purposes because
of the increased risk of personal injury
and damage to the analyzer. Never
attempt to modify the analyzer in any
way since this may result in accidents or
damage to the analyzer.
WARNING
The cordless power tool's motor runs
during the test. Before starting the test,
always take precautions to eliminate the
risk of accidents and injury from contact
with or the operation of the power tool's
attachment.
WARNING
To reduce the risk of injury, no other
person may stand in the area of the
power tool's motor during the test.
WARNING
Before using your analyzer, read and
fully understand all safety precautions
and instructions for the STIHL AP
battery and the STIHL cordless power
tool you are analyzing.
Do not use defective, leaking or
deformed batteries with the analyzer.
WARNING
To reduce the risk of personal injury, do
not operate the analyzer if it is damaged
or not properly assembled. Never use an
analyzer with a defective housing,
adapter or connecting cord to the power
tool or a defective power cord. Do not
ADG 2
operate the analyzer if it has received a
sharp blow or been dropped until it has
been properly checked.
Store analyzer out of the reach of
children.
Protect from rain and
dampness. Keep dry.
Use and store only
indoors in dry rooms.
Connect the analyzer only to an easily
accessible wall outlet with the voltage
and frequency specified on the rating
plate.
Operate analyzer at ambient
temperatures between 41 °F (5 °C) and
104 °F (40 °C).
Never bridge the contacts of the
analyzer with metallic objects (e.g. nails,
coins, jewelry) – short circuit. The
analyzer may be damaged by a short
circuit.
In the event of smoke or fire in the
analyzer, disconnect it from the wall
outlet immediately.
WARNING
To reduce the risk of electric shock do
not insert any objects in the analyzer's
cooling slots.
WARNING
Do not operate in a hazardous location,
i.e. in a location where there are
combustible liquids (fumes), vapors or
dusts. Analyzers can produce sparks,
which may ignite the dust or vapors –
risk of explosion.
Check the analyzer's
power cord, plug, con -
necting cord and adapter
regularly for damage. If
the power cord or plug is
damaged, immediately
disconnect the plug from
the wall outlet to avoid
the risk of electric shock.
Never jerk the power cord to disconnect
it from the wall outlet. To unplug, grasp
the plug, not the cord. Have a damaged
power cord repaired by an experienced
electrician.
Do not use the power cord or connecting
cord for any other purpose, e.g. for
carrying or hanging up the analyzer.
Never use power cords that do not
comply with regulations.
Make sure the power cord is located
and/or marked so that it will not be
stepped on, tripped over, come in
contact with sharp edges or moving
parts or otherwise subjected to damage
or stress.
An extension cord should not be used
unless absolutely necessary. If an
extension cord must be used, plug the
analyzer into a properly wired 16 gauge
(AWG 16) or heavier gauge extension
cord with blades that are the same
number, size and shapes as the blades
on the analyzer.
English
3