Connecting Analyzer To Power Supply; Selecting Language - Stihl ADG 2 Manual De Instrucciones

English
To reduce the risk of electric shock:
Always connect the analyzer to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power cord and plug is in good
condition.
Before leaving the analyzer unattended,
transporting or storing it, remove the
battery and take the adapter out of the
cordless power tool.
Unplug the power cord from the outlet
when analyzer is not in use.
Never store the battery in the analyzer.
Clean plastic components with a cloth.
Do not use aggressive detergents. They
may damage the plastic.
4
Connecting Analyzer to
Power Supply
Mains voltage and operating voltage of
the analyzer must be the same.
3
Insert the mains plug (1) in the wall
N
outlet (2).
The display shows the following
information as soon as the analyzer is
connected to the wall outlet:
Analyzer
ADG 2
The analyzer then performs a self test.
During this process the light emitting
diode (3) on the analyzer glows green
for about 1 second, then yellow, then red
and goes off again.
Self test
When self test is completed:
Insert battery
Insert the battery in the analyzer –
N
see "Testing Cordless Power Tool".

Selecting Language

Connect the analyzer to the power
N
supply – mains voltage and
operating voltage of the analyzer
must be the same – see
"Connecting Analyzer to Power
2
1
Supply".
Wait for analyzer to run self test –
N
there is no need to insert a battery in
the analyzer to select a language.
Press the lower button on the
N
analyzer – see "Main Parts" – for
about 3 seconds to activate
language selection.
Select required language by briefly
N
pressing the upper or lower button.
To confirm the language selected,
N
press and hold down the lower
button on the analyzer for about 3
seconds.
The language can be changed at any
time.
ADG 2