Stihl ADG 2 Manual De Instrucciones página 9

If there is a fault in the cordless power
tool ...
Depending on the fault, the light emitting
diode on the analyzer glows
continuously yellow or red:
Red continuous light: Active fault,
–
cordless power tool not ready for
operation – a damage code is
displayed.
Yellow continuous light: Intermittent
–
fault in the past (e.g. loose contact),
cordless power tool ready for
operation – the fault can be called
up in the power tool's fault memory.
Damage code
XX
The two-digit code on the display
(shown as XX in the description)
indicates the cause of the fault in the
cordless power tool. In case of claims,
always quote the code on the warranty
request form.
Always remove the adapter from the
power tool before starting repair.
Remove adapter before
repair
ADG 2
2
1
Press in both locking tabs (1) at the
N
same time to unlock the adapter (2).
Take the adapter (2) out of the
N
housing.
Press the lower button to confirm.
N
The data of the cordless power tool
remains stored in the analyzer for about
30 minutes.
When the adapter is removed, any
active faults and entries in the fault
memory are shown. Scroll between the
displays with the analyzer's
pushbuttons. For repair procedure, see
Technical Information bulletins on
ADG 2 analyzer and the cordless power
tool concerned.
Clearing the fault memory
The fault memory may be cleared after
completing the repair.
After viewing last entry in fault
N
memory, press the lower button.
Clear memory?
Press both buttons
Press and hold down both buttons
N
for about 3 seconds.
Clear:
Clear:
Press the lower button to confirm
N
that the fault memory should be
cleared.
Insert adapter,
1
switch on unit
Insert the adapter in the cordless
N
power tool.
Switch on the cordless power tool –
N
see power tool's instruction manual.
Fault memory is cleared. To avoid
damage to the electronic module, the
adapter must not be removed from the
cordless power tool and the battery must
not be removed from the analyzer while
the memory is being cleared.
Do not remove unit
On completion, the analyzer's display
confirms that the memory has been
cleared.
Memory cleared
End of test
The test is restarted by pressing the
lower button.
After the test
Remove the battery from the
N
analyzer.
When the battery is removed, the data of
the cordless power tool that has been
tested is deleted from the analyzer. The
analyzer can then be used to test further
cordless power tools.
no
yes
English
7