Joovy Spoon 0012X Manual De Instrucciones página 3

Figure 3.1
Keep children away from walker while making any adjustments to the walker height.
4 Installing the Seat
• Identify the front of the seat and the three plastic posts.
• Starting with the center plastic post, insert the front center post into the front center hole of the walker (See Figure 4.1) and push down to
lock in place. See Figure 4.2.
• Repeat these steps for the other two plastic posts.
• Next, on the rear of the seat there are five straps. Starting with one of the two straps on the outside, feed the strap through the slot in the
back of the walker. See Figure 4.3.
• Make sure that the plastic clip passes all the way through the slot, then turn the plastic clip so that it is flat. See Figure 4.4.
• Repeat these steps for the remaining four straps.
• Pull on the straps and tabs to ensure they are secure.
• Always check walker height adjustment to be sure child's feet touch the floor.
5 Using the Tray In sert
The tray insert is removable and dishwasher safe. This tray has a "Child Resistant" snap. This
design makes the tray insert difficult for a child to remove, while still being easily removed by an
adult.
• To remove the tray insert, flex handles inward, push thumb down on the inner edge of the tray and
pull up. See Figure 5.1.
• To attach the tray insert, fit the tray insert into the tray until both sides click into place.
6 Removing the Seat for Washing
• Starting with the front of the seat, lift up on a post and pull out. See Figure 6.1.
• Repeat these steps for the other 2 plastic posts.
• Next, on the rear of the seat there are five straps. Starting with one of the two straps on the outside, turn the plastic clip so it can be
pushed through the slot, then pull the strap all the way through the slot. See Figure 6.2.
• Repeat these steps for the remaining four straps.
Figure 3.2
Figure 4.1
Figure 4.3
WARNING
!
PINCHING HAZARD
Figure 4.2
Figure 4.4
Figure 3.3
Figure 5.1
EN ES