Dentsply Sirona Cercon xt ML Instrucciones De Uso página 10

General Sinter programs Cercon® xt ML all shades
Material:
Sinter program for bridge frameworks
up to 3 units
Speed-Sinter program for bridge frameworks
up to 3 units
Material:
Sinter program for bridge frameworks up to
3 units
Speed-Sinter program for bridge frameworks
up to 3 units
Material:
Sinter program for bridge frameworks up to
3 units
Speed-Sinter program for bridge frameworks
up to 3 units
1) Room temperature 2) valid for closed sinter bowls, otherwise 1520°C
Sintering programs, Multimat2Sinter / heat DUO / inFire HTC-speed sintering furnace:
Cercon® xt ML speed sintering:
Heating rate Temperature
Step
°C / min
S4 70
S3 70
S2 70
S1 70
Sintering temperatures are recommendations. If necessary, carry out a trial sintering cycle and adapt the sintering temperatures or times as needed.
6
Start- Ramp
Temp. time
°C min
RT 40
1)
RT 90
1)
Start- Ramp
Temp. time
°C °C / min
RT 22
1)
RT 17
1)
Start- Ramp
Temp. time
°C °C / h
RT 1320
1)
RT 1) 1020
Holding time
°C min
750 0
1 100 0
1540 35
0 0
Holding Ramp
Temp. 1 time time
°C min min
900 0 55
1540 35 20
2)
Holding Ramp
Temp. 1 time time
°C min °C / min
900 0 11
1540 35 18
2)
Holding Ramp
Temp. 1 time time
°C h : min °C / h
900 00 : 00 660
1540 2) 00 : 35 1080
Cercon® xt ML standard sintering:
Heating rate
Step
°C / min
S4 31
S3 30
S2 11
S1 22
Holding
Temp. 2 time
Cooling
°C min
With closed furnace
1500 145
cooling down to 200 °C
Gradual opening of the furnace
1150 0
within 35 Min down to 200 °C
Holding
Temp. 2 time
Cooling
°C min
With closed furnace
1500 145
cooling down to 200 °C
Gradual opening of the furnace
1150 0
within 35 Min down to 200 °C
Holding
Temp. 2 time
Cooling
°C h : min
With closed furnace
1500 02 : 15
cooling down to 200 °C
Gradual opening of the furnace
1150 00 : 00
within 35 Min down to 200 °C
Temperature Holding time
°C min
300 0
750 0
1520 130
880 0