CDVI GALEO 4.0 Manual De Instalación página 13

INSTALLATION MANUAL
GALEO 4.0 Bluetooth
Weatherproof Illuminated Keypad with remote electronics
5] WIRING DIAGRAM GALEO 3 RELAY OUTPUTS
P1
keypad to factory default
values. Remove the power
from the keypad then put
the jumper.
P2 jumper allows
to the user to modify
its own Pin code.
To enable this feature put
the jumper on.
Outputs Wiring table
Input voltage 12V to 24VAC or 12V to 48VDC
V
INPUT
Input voltage 12V to 24VAC or 12V to 48VDC
V
N/C contact relay 1
NC
DOOR 1 C Common relay 1
NO N/O contact relay 1
N/C contact relay 2
NC
DOOR 2 Common relay 2
C
NO N/O contact relay 2
NC N/C contact relay 3
DOOR 3 Common relay 3
C
N/O contact relay 3
NO
PB1 Request-to-exit input relay 1
Push
M Common of inputs
button
Request-to-exit input relay 2
PB2
Not used
PX
Clock H Not used
Timer Contact
H
White wire from keypad
+
Keypad
- Brown wire from keypad
TMGALEO
E Green or Blue wire (illumination)
jumper resets the
230 Vca
Alimentación
Input voltage
12/24 Vca
12/48 Vcc
PB1 request-to-exit input activates relay 1.
PB2 request-to-exit input activates relay 2.
Latch or toggled output.
H input can be used with a timer to enable
free access by pressing on any digit key on
the keypad.
When the contact is open
then the request-to-enter is disabled.
When the contact is closed then press any
key on the keypad to enter.
EN
P2 P1
BP1 BP2
PB1 PB2
13
cdvigroup.com