CDVI GALEO 4.0 Manual De Instalación página 16

INSTALLATION MANUAL
GALEO 4.0 Bluetooth
Weatherproof Illuminated Keypad with remote electronics
7] PROGRAMMING
A. FIRST USE OR AFTER RESET
1. Power up the system
On the remote electronics:
- Green LED lights on
- Then the Red LED lights on
- Then the Red and Green LED flash
On the keypad:
- 1 beep is emitted
- The keypad lights on and flashes
2. Enter a new code twice for the master code (only 5 terms).
The 12345 code is forbidden in master code.
- The keypad stop flashing
- After the first entry of the master code, the keypad flashes 1 time
- Enter the second entry of the master code
- If both entry of the master code are the same, 2 beeps are emitted.
Otherwise, wait until the keypad flashes again to enter the new master code twice
(about 10 seconds)
- Entry in programming mode
3. Configure the system with the programming chart
- Press B to exit from programming mode
B. RESET MEMORy
1. Cut off the power and put the jumper on P.
- Refer to page 13 for the jumper P1 on the remote electronics
2. Put the power back :
On the remote electronics:
- Red LED lights on during reset
- After the reset, Red and Green LEDs still flashing while waiting new master code
On the Keypad:
- 6 short beeps are emitted during reset and at the end 1 long beep is emitted
- The keypad still flashing while waiting new master code
3. Pull out the jumper on P1
- Master code and user codes are cleared and set to default value
4. Start again from part A
16
cdvigroup.com
EN