CDVI GALEO 4.0 Manual De Instalación página 17

INSTALLATION MANUAL
GALEO 4.0 Bluetooth
Weatherproof Illuminated Keypad with remote electronics
C. RESET MASTER CODE
On stand-by operating mode, put a jumper on P1. Wait until the keypad flashes to enter new
master code.
On the remote electronics:
- Red LED lights on during the reset of the master code
- Then Green LED lights on
On the keypad:
- 3 short beeps are emitting during the reset of the master code and after that
1 long beep is emitted
- The keypad flashes while waiting the entry of a new master code
D. CHANGING THE CODE By A USER
To authorize a user to modify its own user code, put a jumper on P2 (to disable the feature,
remove the jumper)
1. Enter the current user code
- The relay is activated and a beep is emitted
2. Enter the 2 digits sub master code
- Relay 1, default sub master code: A and B
- Relay 2, default sub master code: 1 and 3
- Relay 3, default sub master code: 4 and 6
- A beep is emitted to authorize the modification
3. Enter the new user code
- 2 beeps are emitted to confirm the new code
4. Check the new user code to be sure of the modification
EN
17
cdvigroup.com