Assembly Of Lock - Garant heavy-duty rack Manual De Instrucciones

4.5.4 Assembly of lock

X
X
X
In the case of the assembly of several pull-out shelves, it may be necessary
to re-adjust the locking piece so that the pin is always at the top in the
shaped slot. Also pay attention to the correct seating of the catch pin (must
engage).
50
I
Push locking rod (E) up until it engages.
Fasten the locking piece (K) to the pull-out shelf (I) using 2 hex screws
M8×20 (M) and 2 plain washers (Q) so that the pin has approx. 1–2 mm
clearance to the top of the shaped slot (OF) of the locking rod (E).
Also use Loctite threadlocker on screw connections! This prevents
the locking pins from moving out of place over time as a result of the
mechanical load.
OF

E
K
Q
M