Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
button once again; the display will briefly indicate
To switch off, keep the button
the display indicates
6 Settings
To make settings via the buttons SET,
(5), remove the cap (3): Slightly press the
grooved latch on the rear to remove the cap
1) To call up the setting mode, keep the but-
ton SET pressed for 3 seconds: The display
indicates
lected ("Selecting a frequency from a group"
or "Setting the frequency directly", whichever
function was used to set the current transmis-
sion frequency)
2) To select a function, use the button SET:
Press the button repeatedly until the desired
function is reached
Overview of functions
1. "Selecting a frequency from a group"
(or "Setting the frequency directly")
2. "Setting the frequency directly"
(or "Selecting a frequency from a group")
3. "Adjusting the sensitivity"
4. "Selecting the transmission power"
5. "Key lock"
3) To change the setting, use the button
When a function offers two setting options
(e g group number and channel number),
use the button SET to go from the first option
to the second option
4) To save the setting, press the button SET
The display indicates
mode is exited
If no setting has been changed when the last
function is reached, the setting mode will be
exited when the button SET is pressed (indication
)
For detailed information on the functions refer to
the following chapters
10
pressed until
and the first function is se-
and the setting
6.1 Selecting a frequency from a group
Just like on the receiver US-36G2/5, the trans-
mission frequency can be selected from one of
the 6 preset groups (overview:
detailed information on this function refer to the
instructions of the receiver
1) The group number (in front of the hyphen)
and
starts flashing on the display: Use the button
or
2) Press the button SET
3) The channel number starts flashing on the
display: Use the button
channel
4) To save the setting, press the button SET
6.2 Setting the frequency directly
Just like on the receiver US-36G2 /5, the desired
frequency can be selected from 1441 available
frequencies
1) The first three digits of the transmission fre-
quency start flashing on the display: Use the
button
of 1 MHz
2) Press the button SET
3) The last three digits of the transmission fre-
quency start flashing: Use the button
to set the frequency in steps of 0 025 MHz
4) To save the setting, press the button SET
6.3 Adjusting the sensitivity
or
The volume of the microphone can be adjusted
via the microphone sensitivity (which is adjustable
in steps of 3 dB from −18 dB to +12 dB) Adjust
the sensitivity in such a way that an ideal volume
level of the microphone is obtained When the
volume is too high, the microphone signal will
distort; in this case, adjust a lower value When
the volume is too low, the signal-noise ratio will
be poor; in this case, adjust a higher value
1) The display indicates the current sensitivity in
dB Use the button
or the button
2) To save the setting, press the button SET
to select the group
or
or
to set the frequency in steps
to adjust a higher value
to adjust a lower value
page 3) For
☞
to select the
or
Publicidad
Tabla de contenido
