Setting The Frequency Manually; Selecting A Frequency From A Group; Adjusting The Transmission Power - Monacor JTS JSS-4B/5 Manual De Instrucciones

– Identification number –
To prevent mutual interference of individual
pairs of microphone/receiver during REMOSET
transmission, each pair must have a different
identification number (ID No ) If you only use
one pair of microphone/receiver, there is no
need to change the preset ID No 1 To change
the ID No :
1) Call up the setting for the ID No via the
menu item
menu
Remoset ID
1
ID : ON
2) Press the button  or  to set the ID No
3) Press the button SET Then press the button
 to deactivate the function (OFF) or the
button  to activate the function (ON) If the
function has been deactivated, the REMOSET
transmission will be possible from any R­4 / 5
receiver; if the function has been activated,
the REMOSET transmission will only be pos­
sible from a receiver with the same ID No
4) Press the button SET to save the setting
– REMOSET transmission –
Press the button REMOSET on the receiver As
soon as the microphone has been set to the
transmission frequency or to the group and the
transmission channel of the receiver, the LED (3)
shows blue for five seconds and the display in­
dicates
Sync...
If the LED does not show blue, the auto­
matic synchronization of the microphone has
failed For troubleshooting see steps 1 – 4 at the
beginning of this chapter Check the settings on
the microphone and possibly on the receiver and
correct them Then press the button REMOSET
on the receiver again
– Disabling the REMOSET function –
The REMOSET function can be disabled to pre­
vent automatic setting:
1) Call up the menu item
main menu
Remoset
ON
OFF
16
of the main
5. Remoset ID
Fig. 7
6. Remoset
Fig. 8
2) Press the button  to disable the func­
tion (OFF) or the button  to enable the
function (ON)
3) Press the button SET to save the setting

3.6.2 Setting the frequency manually

1) Call up the frequency setting via the menu
item
1. Frequency
Frequency
507.500
G: 1 C: 1
2) Press the button  or  to set the frequency
in steps of 1 MHz
3) Press the button SET so that the digits after
the decimal point are highlighted To make a
fine adjustment in steps of 0 025 MHz, press
the button  or  If the frequency is identi­
cal to the frequency of a channel in a group,
the group and channel numbers are indicated
in the lower line
4) Press the button SET a second time to save
the frequency selected

3.6.3 Selecting a frequency from a group

1) Call up the group and channel selections via
the menu item
main menu
Group/Channel
G: 5
506.175 MHz
2) Press the button  or  to select the group
3) Press the button SET to highlight the channel
number Then press the button  or  to se­
lect the channel The corresponding transmis­
sion frequency is indicated in the lower line
4) Press the button SET to save the setting

3.7 Adjusting the transmission power

1) Call up the menu item
RF Power
in the
2) Press the button  for the setting
the button  for the setting
= high power (50 mW): high range,
High
of the main menu
Fig. 9
2. Group/Channel
C: 1
Fig. 10
7. RF Power
High
Low
Fig. 11
but short battery life
of the
or
Low
High