Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
starts flashing To unmute the sound, press the
button once again; the display will briefly indi-
cate
To switch off, keep the button
until the display indicates
6 Settings
To make settings via the buttons SET,
(5), remove the cap (3): Slightly press the
grooved latch on the rear to remove the cap
1) To call up the setting mode, keep the but-
ton SET pressed for 3 seconds: The display in-
dicates
("Selecting a frequency from a group" or
"Setting the frequency directly", whichever
function was used to set the current trans-
mission frequency)
2) To select a function, use the button SET:
Press the button repeatedly until the desired
function is reached
Overview of functions
1. "Selecting a frequency from a group"
(or "Setting the frequency directly")
2. "Setting the frequency directly"
(or "Selecting a frequency from a group")
3. "Adjusting the sensitivity"
4. "Selecting the transmission power"
5. "Key lock"
3) To change the setting, use the button
or
When a function offers two setting
options (e g group number and channel
number), use the button SET to go from the
first option to the second option
4) To save the setting, press the button SET
The display indicates
mode is exited
If no setting has been changed when the last
function is reached, the setting mode will be
exited when the button SET is pressed (indica-
tion
)
For detailed information on the functions refer
to the following chapters
10
and the first function is selected
and the setting
6.1 Selecting a frequency from a group
Just like on the receiver US-36G2 / 5, the trans-
mission frequency can be selected from one of
the 6 preset groups (overview:
pressed
detailed information on this function refer to
the instructions of the receiver
1) The group number (in front of the hyphen)
starts flashing on the display: Use the button
and
or
2) Press the button SET
3) The channel number starts flashing on the
display: Use the button
channel
4) To save the setting, press the button SET
6.2 Setting the frequency directly
Just like on the receiver US-36G2 / 5, the desired
frequency can be selected from 1441 available
frequencies
1) The first three digits of the transmission fre-
quency start flashing on the display: Use the
button
of 1 MHz
2) Press the button SET
3) The last three digits of the transmission fre-
quency start flashing: Use the button
to set the frequency in steps of 0 025 MHz
4) To save the setting, press the button SET
6.3 Adjusting the sensitivity
The volume of the microphone can be adjusted
via the microphone sensitivity (which is adjust-
able in steps of 3 dB from −18 dB to +12 dB)
Adjust the sensitivity in such a way that an ideal
volume level of the microphone is obtained
When the volume is too high, the microphone
signal will distort; in this case, adjust a lower
value When the volume is too low, the sig-
nal-noise ratio will be poor; in this case, adjust
a higher value
1) The display indicates the current sensitivity
in dB Use the button
value or the button
2) To save the setting, press the button SET
to select the group
or
or
to set the frequency in steps
to adjust a higher
to adjust a lower value
page 3) For
☞
to select the
or
Publicidad
Tabla de contenido
