6 3 Selecting A Frequency From A Group; 7 Adjusting The Transmission Power; 8 Adjusting The Microphone Sensitivity; 9 Low-Cut Filter - Monacor JTS JSS-20/5 Manual De Instrucciones

3.6.3 Selecting a frequency from a group
1) Call up the group and channel selections via
the menu item
2. Group/Channel
main menu
Group/Channel
G: 2 C: 1
530.375 MHz
2) Press the button  or  to select the group
3) Press the button SET to highlight the channel
number Then press the button  or  to se­
lect the channel The corresponding transmis­
sion frequency is indicated in the lower line
4) Press the button SET to save the setting

3.7 Adjusting the transmission power

1) Call up the menu item
RF Power
High
Low
2) Press the button  for the setting
the button for the setting
= high power (50 mW): high range,
High
but short battery life
= low power (10 mW): long battery
Low
life, but short range
3) Press the button SET to save the setting
3.8 Adjusting the
microphone sensitivity
The sensitivity adjustment is used to match the
microphone to the volume of the voice or the
instrument
1) Call up the menu item
Sensitivity
0 dB
2) Adjust the sensitivity according to the indi­
cation AF of the receiver in such a way that
an optimum signal level is obtained If the
sensitivity is too high, the microphone signal
of the
Fig. 11
7. RF Power.
Fig. 12
Low
High
3. Sensitivity.
Fig. 13
will distort; in this case, press the button  to
set a lower value (min −15 dB) If the volume
is too low, there will be a poor signal­to­noise
ratio; in this case, press the button  to set
a higher value (max +15 dB)
3) Press the button SET to save the setting
Note: The setting
directly on the receivers UF­20R / 5 and UF­20S / 5 via
the REMOSET function (refer to the instruction manual
of the receivers)

3.9 Low-cut filter

To suppress low frequencies (e g impact sound,
rumble), a low­cut filter (100 Hz, 18 dB/octave)
can be activated
1) Call up the menu item
LOW CUT
ON
2) Press the button  to activate the filter (ON,
or
symbol ) or press the button  to deacti­
vate the filter (OFF, symbol
3) Press the button SET to save the setting
Notes:
1 In the setting
Low Cut ON
activated, the symbol
an indication
2 The setting
Low Cut
the receivers UF­20R / 5 and UF­20S / 5 via the REMO­
SET function (refer to the instruction manual of the
receivers)

3.10 Muting the microphone

To briefly mute the microphone, e g in speech/
music pauses, briefly press the button
LED (3) keeps flashing in red and the display
periodically indicates
the receiver UF­20R / 5 or UF­20S / 5 lights up in
red and the message
cally appears To unmute, press the button
once again
Note: When the keys are locked (chapter 3 11), the
muting function is locked as well
can also be made
Sensitivity
4. Low Cut.
Fig. 14
)
, when the menu is de­
appears on the display as
can also be made directly on
The display of
Mute ON
Mic. Mute
(9) The
periodi­
17