5�1 Colour Change Programs; 5�1�1 Music Control; 5�2 Strobe Effect; 5�3 Modifying The Speed Of Programs And The Speed Of The Strobe Effect - IMG STAGELINE LC-324DMX Manual De Instrucciones

5.1 Colour change programs
The controller offers three automatic programs .
To call up a program:
1) Use the buttons FIXTURE (1) to select /dese-
lect the corresponding spotlights . When a
spotlight has been selected, the LED of the
corresponding button will light up .
2) Use the buttons PROGRAM to select one of
the following programs:
12 COLOUR = colour change with 12 colours
3 COLOUR = colour change with 3 colours
COL . FADE = colour fading with 7 colours
3) Use the buttons T+ and T− (2) to change the
program speed as required (
4) To exit the program, press the program but-
ton once again or select a different program .
Only the spotlights currently selected will exe-
cute the program . When a spotlight is deselect-
ed during a program, this spotlight will retain
its setting .
5.1.1 Music control
The two colour change programs 12 COLOUR
and 3 COLOUR can be controlled to the rhythm
of music picked up via the integrated micro-
phone (5) .
1) Call up the program 12 COLOUR or 3 COL-
☞
OUR ( chapter 5 .1) .
2) Press the button SOUND (8) . The LED of the
button will light up to indicate that the music
control has been activated .
3) Use the control MIC SENS (6) to match the
sensitivity of the microphone to the volume
of the music as required .
4) To deactivate the music control, press the
button SOUND once again .
5.2 Strobe effect
Not every spotlight is equipped with a strobe
channel; therefore, the controller offers a strobe
effect . Unlike the colour change programs, the
strobe effect will apply to all spotlights, not only
to the spotlights selected .
14
1) As described at the beginning of chapter 5,
2) Press the button STROBE in the zone
3) Use the buttons T+ and T− (2) to change
4) To deactivate the strobe effect, press the but-
5.3 Modifying the speed of programs
The speed of a colour change program or the
☞
chapter 5 .3) .
speed of the strobe effect can be modified:
During the program or when the strobe effect
has been activated, press the button T− in the
zone COLOUR (2) to increase the speed or the
button T+ to reduce the speed . The duration of
the current program step or the time between
strobes will be briefly displayed in binary format
in the upper two rows of green LEDs:
T+
Note: When the program speed is changed, there will
be a delay of one program step (1 minute max .) before
it takes effect .
make the desired settings for colour or
brightness for all spotlights .
PROGRAM (3) . The LED of the button will
light up .
the strobe rate as required (
ton STROBE once again .
and the speed of the strobe effect
RED LIGHT RED ORANGE YELLOW
RED
GREEN LIGHT GREEN CYAN WHITE
GREEN STROBE WHITE
BLUE LIGHT BLUE MAGENTA PURPLE
BLUE MASTER
Indication
3 COLOUR
12 COLOUR
1 min /colour
⋮ ⋮
0.25 s /colour
Indication
⋮
☞
chapter 5 .3) .
2 2 2 2 2 2 2 2
T−
Setting range
COL. FADE
37 s /colour
⋮
0.2 s /colour
Setting range
STROBE
0.8 strobes /s
⋮
16 strobes /s