Ryobi P3260 Manual Del Operador página 8

NOTICE:
Monitor the debris canister during use and empty as
needed. Operating the sweeper with a full debris canister
can damage the tool.
NOTICE:
Do not push the unit forward, unless the motor is ON.
Pushing the unit with the motor OFF could deform the
rotating brushes.
 Determine the appropriate brush height and adjust
deflectors as needed.
 Adjust the handle assembly to a comfortable operating
position and height.
 Install the battery pack.
 Stand behind the sweeper with your hands on the handle
grips.
 Depress the on/off button with your foot to start the motor.
NOTE: When the motor is ON, the rotating brushes
will spin continuously and the LED headlights will
automatically turn on. The left and right brushes rotate
in opposite directions.
 Push the unit over the surface to be cleaned.
NOTE: The sweeper is only designed to operate in a
forward direction. Do not pull the unit backwards.
NOTE: If the sweeper becomes clogged, the motor will
automatically stop and LED headlights will flash for 10
seconds. Before resuming operation, remove the battery
pack and clear the obstruction.
OPERATION
 When sweeping is complete, bring the unit to a halt,
depress the on/off button to turn the motor OFF, and wait
for the brushes to stop spinning.
NOTE: When the motor is OFF, the rotating brushes will
stop spinning and the LED headlights will turn off.
 Remove the battery pack.
 Remove and empty the debris canister as described later
in this section.
EMPTYING THE DEBRIS CANISTER
See Figures 10 - 11, page 12.
CAUTION:
Some debris may contain sharp edges that may cause
personal injury. Wear protective gloves if necessary.
 Turn the motor OFF and remove the battery pack.
 Slide the latch toward the back of the unit and, using the
handle, remove the debris canister from the sweeper.
 Empty and clean the debris canister.
NOTE: Always dispose of debris properly. Check with
local codes for possible special disposal instructions.
 To replace the canister, slide and hold the latch back and
place the canister back in the sweeper.
 Release the latch to secure the canister in place.
 Gently pull up on the canister handle to ensure the
canister is secured.
8 — English