Assembly; Operation - Ryobi P131 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging RYOBI 18V Li-Ion battery packs
CAUTION:
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Take the charger and battery to your nearest
service center for service or replacement.
CAUTION:
Always place the charger on a rigid surface, not a car
seat, while charging battery pack. Do not place anything
such as a jacket over the charger while it is in use.
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
KEY HOLE HANGER
See Figure 1, page 8.
To mount the charger, only use the key hole hanging feature.
Screws should be installed so that the center distance is
4-1/8 in.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

LOW VOLTAGE ALARM
Provides audible warning and shuts down charger when
vehicle's battery cannot supply appropriate power.
12 VOLT ADAPTOR
See Figure 1, page 8.
The adaptor connects the charger to a 12 Volt power source,
such as a cigarette lighter receptacle or automotive power
port.
Refer to the operator's manual for the vehicle or contact
the vehicle manufacturer for the proper power receptacle.
CAUTION:
If the 12 Volt adaptor does not fit firmly into the cigarette
lighter receptacle or power port, the receptacle may not
be suitable for use with the charger. A poor connection
at the base of the 12 Volt adaptor could lead to electrical
problems in the vehicle outside of the protections offered
by the vehicle or charger's fuse.
Hold the barrel plug firmly and insert into the power port.
The red POWER LED will come on.
CHARGING
See Figure 2, page 8.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time is approximately 30 minutes and is dependent
upon the type of battery pack.
 Make sure the power supply is 12 Volt DC.
 Connect the charger to a power supply.
 Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack into the charger.
4 — English