Assembly; Operation - Ryobi P125 Manual Del Operador

UNPACKING
This product has been shipped completely assembled.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Charger
Wall Mount Bracket
Operator's Manual
ASSEMBLING WALL MOUNT BRACKET
See Figures 2 - 3, page 8
 Find desired location indoors and away from any objects
that could block vents on charger. Locate a wall stud to
securely mount bracket.
 You will need two #8 - 2 1/2 in. screws (not included)
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating products. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging and maintaining Ryobi One+ 18 V battery packs
at peak charge over time.
NOTE: Charger charges batteries one at a time, charger does
NOT charge multiple batteries simultaneously.

ASSEMBLY

 Use a level to be sure that bracket is in a vertical posi-
tion. Use a pencil to mark screw hole placement. Screws
should be installed so that the center distance is 15 in.
 Install screws to securely attach bracket.
 Place bottom end of charger into bracket then snap top
of charger securely into bracket.
 Charger should fit snugly and securely in bracket.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.

OPERATION

CAUTION:
Charge in a well ventilated area. Do not block
vents. Keep them clear to allow proper ventilation.
CAUTION:
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Take the charger and battery to your nearest
service center for service or replacement.
BATTERY PROTECTION FEATURES
Ryobi One+ 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.
5 — English
charger