Maintenance And Replacement Of Parts - FlexiForce RS200 Manual De Instalación, Utilización Y Mantenimiento

manual

MAINTENANCE AND REPLACEMENT OF PARTS

RESIDENTIAL DOORS
An overhead door should be maintained and checked regularly to ensure safe operation and
use. This is described in the EN-norms.
GENERAL:
1 Torsion springs, brackets and other components which are attached to the springs
and cables, are under extreem tension. If not handled properly, injuries or damages
might occur!
So, working on these components may only be carried out by qualified
overhead door mechanics!
2 Replacement of broken or weared components should always be done by qualified
overhead door mechanics.
3 When checking the door, always disconnect the electrical main power supply. Make
sure that it is blocked against re-engaging without you knowing it.
REGULAR MAINTENANCE:
After installation:
1. Grease running part of the tracks
2. Grease the bearings of the rollers
3. Grease the shafts of the rollers
4. Grease the bearings of the shaft
5. Grease the hinge pins
6. Grease the lock
7. Protect the panels with carwax
8. Grease the rubbers slightly with vasaline
After 3 months:
1. Complete inspection visualy
2. Check balancing system and adjust if needed
3. Grease all the above mentioned points if needed
Every 6 months (or after every 750 cycles):
1. Check side seals on damage or wear and tear
2. Check top seal on damage or wear and tear
3. Check bottom seal on damage or wear and tear
4. Grease all above mentioned points
5. Clean the panels
6. Clean the windows (only water wash, do not use cloth)
7. Remove dirt and waste from the door or its surroundings
Every 12 months (or after every 1500 cycles):
1. Check or test the fixation of the springs to the fittings
2. Check the balance of the door and adjust if needed
3. Check the cables for damage or wear and tear
4. Check the cable connection points on drums and bottom bracket
5. Check the roller on wear and free moving space
6. Check the hinges on breaking
GB
rev.0 Feb-09
RS200 manual GB 2009
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
USER
USER
MECHANIC
MECHANIC
MECHANIC
USER
USER
USER
USER
USER
USER
USER
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
www.flexiforce.com
30