Using The Time Recorder/Stamp; Making A Test Print; Setting The Time - Amano PIX-200 Manual De Instrucciones

USING THE TIME RECORDER/STAMP

Make sure the AC adapter is plugged in while you make changes on the settings.
NOTE: Once you finish changing the settings, put the cover on to exit from the set up program
mode and return to normal operation mode.
NOTE: Replacing the cover will also lift up the printer carriage in case it stays down.

Making a Test Print

1. Make sure the AC adapter is plugged in.
2. The LED lights up and illuminates the printing position.
3. Insert a piece of paper or time card along the guide.
The unit will automatically print YEAR, MONTH, DATE
and TIME with AM or PM (Imprint Format No.3).
IMPRINT SAMPLE;
4. If the imprint is satisfactory, the PIX-200 is ready for use.

Setting the Time

The illustration on the right shows a sample of the display. The shaded
area means that the symbols, numbers or characters are blinking.
1. Unlock and remove the cover.
2. Press (+) and (E) button at the same time for 2 seconds.
The "set up program" display will appear.
3. Press the (E) button to set the Hour. While the Hour display is blinking
adjust the hour using (-) and (+) button. Press (E) button to confirm.
4. While the Minute display is blinking, adjust the minute using (-) and (+)
button. Press the (E) button to confirm the minute. The seconds will
start from "00" at the time you press the (E) button. However, if you
do not change the minute, the seconds will not start from "00".
6
(If the Time Displayed is Incorrect)
Guide
Blinking
:
:
:
: