Setting The Customized Comments - Amano PIX-200 Manual De Instrucciones

Setting the Customized Comments

Maximum 3 lines comment can be set to print.
The maximum printing length per line is 35mm. You can check the length
at the end of the setting.
(Refer to page 25 "Diagram of Character Code" to select the character)
1. Follow step 1 to 3 on page 8. At step 3, select 32.
2. Once you confirm 32 by pressing (E) button, the "P1 inPut CodE"
display appears.
3. Press (E) button to program the 1
that you can program the 1
number shows the printing length of the comment in mm.
Press (E) button while "1" is blinking.
4. You will see the "LinE1 1" display with "En" blinking. "LinE1 1" means
st
the 1 character on Line 1, and "En" means the end of the sentence.
5. Press the (-) or (+) button and select the character code referring
to the Diagram of character code (page.25).
Press (E) button every time you confirm one character.
6. Once you finish selecting the characters for line 1, press (E).
You will go back to "P1 inPut CodE" Display.
7. To enter the comments on Line 2, Press (E) and press (+) when
the line number is blinking. You can program Line 3 by taking
the same steps.
8. Once you finish programming Customized Comments, press (E) and
Go back to the "P1 inPut CodE" Display.
9. If you want to check the printing length, press (E) button and select
the line by pressing (-) or (+) button. You will see the length in
mm to the left of the blinking line number.
(The sample display on the right shows that Line 1 is 35mm)
NOTE: When the value exceeds the maximum length, the "error 05" will
appear on the display when you put the cover on. (Refer to page 22).
NOTE: You can choose the character font when programming the
customized comments. In order to make the imprint clearer, we recommend you to use Two-Byte
Font. Please refer to page 26 "Diagram of Font".
st
line. "Prn LinE 1" display means
st
line. The "0" on the left side of the Line
9