Performing An Emergency Stop; Activating An Emergency Release On The Control Unit; Cbj Home Control Unit; Cbj Care, Cbj1, Cbj2 Control Unit - Invacare Birdie EVO Serie Manual Del Usuario

Removing the spreader bar
1.
1. Push and hold the release button up.
2. Slide the spreader bar out in a forward and slightly
upward direction.
Attaching a spreader bar
1. Slide the spreader bar
in until you hear an
audible click.
2. Check that the spreader
bar is firmly attached
to the boom connector
and cannot be removed
without pressing the
release button.

5.6 Performing an emergency stop

1. Press the red emergency button A on the control unit
to stop the boom and patient from raising or lowering.
2. To reset, rotate the emergency button clockwise.
5.7 Activating an emergency release on the
control unit

5.7.1 CBJ Home control unit

If the hand control fails, the boom can be lowered by using
the circular switch for emergency release.
1. Lower the boom by pressing and holding button A at
the front of the control unit.
2. Stop lowering the boom by releasing the button.
1650023-A
2.

5.7.2 CBJ Care, CBJ1, CBJ2 control unit

Emergency lowering
If the hand control fails, the boom can be lowered by using
the circular switch for emergency release. Use a sharp
object, such as a pencil to press the button.
1. Lower the boom by pressing and holding button A at
the front of the control unit.
2. Stop lowering the boom by releasing the button.
Emergency lifting
(not available on CBJ2)
If the hand control fails, the boom can be raised by using
the circular switch for emergency lifting. Use a sharp object,
such as a pencil to press the button.
1. Raise the boom by pressing and holding button B at the
front of the control unit.
2. Stop raising the boom by releasing the button.

5.8 Activating an emergency release manually

For the case of partial or total power failure, or if the battery
runs down while using the lift is equipped with a manual
emergency release system.
It is recommended that the primary emergency
release be used. The secondary (manual) emergency
release is only a back-up to the primary emergency
release.
Birdie® EVO and Birdie® EVO PLUS
The manual emergency release system is located at the
bottom of the actuator piston.
1. Pull up on the red
emergency grip A
and push down on the
boom at the same time.
The manual emergency release system will only operate with
a patient in the lift. It can be adjusted according to the
patient's weight as described below. The weight is preset to
75 kg.
Adjusting the lowering speed for manual emergency
lowering:
1. Locate the screw on top of the red emergency grip A.
2. Loosen the screw to increase the speed.
3. Tighten the screw to decrease the speed.
Birdie® EVO COMPACT
(optional)
Usage
13