Transportation And Storage; General Information; Disassembling The Mast From The Base; Folding The Mast - Invacare Birdie EVO Serie Manual Del Usuario

7 Transportation and Storage

7.1 General information

During transportation, or when the patient lift is not to be
used for some time, the emergency stop button should be
pushed in.
A folded or disassembled lift can be located in the packaging
box, for transportation and storage.
Folded lifts can be pulled on the rear wheels and lifts with
a manual leg spreader can be parked in an upright position
with the mast/boom assembly pointing upwards.
The patient lift must be stored at normal room temperature.
If it is stored in a damp, cold or wet environment then the
motor and other mounting parts may be prone to corrosion.
See 11.4 Environmental conditions, page 27.

7.2 Disassembling the mast from the base

(fixed mast only)
1. Remove optional leg spreader lever if attached.
2. Lower the boom and narrow both legs completely.
1650023-A
3. Activate the emergency stop button and apply castor
brakes.
4. Reverse the procedure described in 4.5 Installing the
actuator to the boom, page 10
5. Reverse the procedure described in 4.4 Unfolding the
spreader bar, page 10
6. Reverse the procedure described in 4.3.2 Assembling the
mast to the base, page 10

7.3 Folding the mast

(foldable mast only)
1. Remove optional leg spreader lever if attached.
2. Lower the boom and narrow both legs completely.
3. Activate the emergency stop button and apply castor
brakes.
4. Reverse the procedure described in 4.5 Installing the
actuator to the boom, page 10
5. Reverse the procedure described in 4.4 Unfolding the
spreader bar, page 10
6. Reverse the procedure described in 4.3.1 Unfolding the
mast, page 9 and pull and hold the safety catch F
upwards before folding down the mast.
Transportation and Storage
21