Replacing The Cartridge; Trouble-Shooting; Frequently Asked Questions - Beurer SalonPro System IPL 10000+ Instrucciones De Uso

IMPORTANT
Never immerse the beurer SalonPro System or any of its parts in water!
• Before cleaning, unplug the mains plug of the beurer SalonPro System.
• Use a clean, dry cloth and cleaning agent especially intended for electronic devices to gently wipe
the surface of the beurer SalonPro System, paying particular attention to the light surface.

9.2 Replacing the cartridge

The cartridge has a life cycle of up to 250,000 light pulses, which is sufficient for up to 40 years for nor-
mal use (one user, full body treatment including legs, arms, armpits, bikini zone and face). This means
that the cartridge for this model does not usually need to be replaced.
Note
The cartridge should only be replaced if there are large spots visible or if the lens is broken. If this is
the case, please contact Beurer Customer Services.

10. Trouble-shooting

"My beurer SalonPro System cannot be switched on"
• Ensure that the mains cable is correctly connected to the beurer SalonPro System device.
• Ensure that the mains cable is inserted into a wall socket.
"No light pulse is emitted when I press the trigger button"
• Ensure that the device is in full contact with the skin and that the light area is pressed onto the skin
evenly and firmly. For your safety, the trigger button only activates a pulse if the light area is pressed
firmly against the skin.
• Check the indicator lamp. If the indicator lamp on the applicator is illuminated red, this indicates that
your skin colour, as measured by the skin colour sensor, is too dark for safe application. Test the
device on another part of your body or contact beurer SalonPro System Customer Services.
If the indicator lamp on the applicator is illuminated orange, this indicates that the contact with the
skin, as measured by the skin contact sensor, is insufficient. Increase the level of contact with the
skin or contact beurer SalonPro System Customer Services.
• In the event of a general fault, all six energy indicator lamps flash green simultaneously. Reset the
device. To do this, switch the device off at the mains switch, wait for 30 seconds, then switch the
device back on at the mains switch. Should you still have problems with your device, please contact
Customer Services.
• Check the indicator lamp. If the indicator lamp on the applicator is flashing red and theindicator lamp
on the device is flashing green, this indicates that the cartridge is not inserted correctly in the applica-
tor. Reinsert the cartridge into the applicator.

11. Frequently asked questions

1. Does the beurer SalonPro System really work?
Yes. In clinical tests performed by doctors, it was proven that the technology in the beurer SalonPro
System can be used to achieve lasting hair removal results.
2. On which parts of my body can I use the beurer SalonPro System?
The beurer SalonPro System was designed for hair removal all over the body. The most common areas
that are treated with the beurer SalonPro System are the legs, armpits, arms, bikini zone and the face
below the cheekbones.
3. How long does a treatment session using the beurer SalonPro System last?
The time can vary depending on the area of the body being treated. A full body treatment (legs, arms,
armpits, bikini zone and face below the cheekbones) takes approximately 26 minutes. As the beurer
40