Setting Into Operation - Monacor MKA-50SET/WS Manual De Instrucciones

3 Setting into Operation

Connection
Control element
Making connections
RIGHT SPEAKER
INPUT
230 V~ / 50 Hz
Operation
POWER
ON
VOLUME
BASS + TREBLE
MONO STEREO
—
4 Specifications
Frequency range: . . . . . . 60 – 20 000 Hz
Amplifier power
Total output power: . . 2 × 40 W
Power rating (RMS): . . 2 × 20 W
Amplifier power: . . . . . . . 2 × 20 W RMS,
Max . SPL: . . . . . . . . . . . . 102 dB for each speaker
Inputs
Sensitivity: . . . . . . . . . . 420 mV
Impedance: . . . . . . . . . 24 kΩ
Connection: . . . . . . . . RCA jacks and
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
Function
Connect the passive speaker (without amplifier) to this terminal . Always observe the
correct polarity (never confuse the positive and negative connections) .
Connect the signal source (e . g . MP3 / CD player, mixer, computer) to the RCA jacks or
to the 3 .5 mm jack . For mono operation, the signal will be fed to the RCA jack "L"
only (also refer to the line STEREO MONO, second to last) .
Use the mains cable provided to connect the mains jack to a socket (230 V/ 50 Hz) .
The fuse support is below this jack . Always replace a blown fuse by one of the
same type!
Power switch (on / off) . Before switching on, turn the control VOLUME counter-clock-
wise to make sure that the initial volume is not too high .
Power LED; will light up when the active speaker has been switched on .
Control to adjust the desired volume .
Tone controls to adjust the sound .
Selector switch for mono or stereo operation .
When the switch is set to mono, only the left channel will be reproduced .
If there is no input signal for approx . 2 minutes, the active speaker will go to
stand-by: The LED ON will extinguish . As soon as a signal (> 5 mV) is applied, the
speaker will be switched on again .
2 × 40 W max .
system
3 .5 mm jack
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
Tone controls
BASS: . . . . . . . . . . . . . ±12 dB / 50 Hz
TREBLE: . . . . . . . . . . . . ±12 dB / 10 kHz
Power supply: . . . . . . . . . 230 V/ 50 Hz
Power consumption
Operation: . . . . . . . . . 110 VA max .
Stand-by: . . . . . . . . . . 0 .3 VA
Ambient temperature: . . 0 – 40 °C
Dimensions (W × H × D): 180 × 250 × 160 mm
Weight (pair): . . . . . . . . . 5 .9 kg
Subject to technical modification .
7