Updating The Firmware - Yamaha CD-NT670 Manual De Instrucciones

Updating the firmware

When a new firmware for the unit is released, a message to update your current firmware will be shown on the front panel display (when the unit is connected to the Internet only).
In this page, an updating method via a network using the option setting is shown.
1
Press .
• The option menu is shown on the front panel
display.
2
Select [Firmware Update] with
and press .
3
Select [Update] with / and press
4
Select [Network] with / , and press
.
• Press ENTER again, then update starts.
• When update finishes, messages are shown in the
following order: "UPDATE SUCCESS", "PLEASE ...",
and "POWER OFF!"
5
Press A on the front panel.
• Update is applied.
/ ,
.
• Do not operate the unit or disconnect the power
cable and network cables while updating.
• When Internet speed is not fast enough or the unit
is connected to the wireless network via a wireless
network adapter, network update may not be
possible depending on the condition of the
wireless connection. In this case, try again or update
the firmware using a USB memory device. The
firmware can be downloaded from the Yamaha
Website.
To update the firmware using a USB memory
device
1
You can download the firmware to the USB memory
OPTION
device, and connect that USB memory device to the
USB jack on the unit.
• Select [USB] in step 4 to start the update.
2 3 4
, ,
/
ENTER
45
En