Display; First Installation; Batteries Installation; Time And Date Adjustment - Watts BT-TH02 RF Guía De Usuario

1.2

Display

1: Current day of the week.
2: Operating mode menus (active mode is framed).
Program number or parameter number if " " is
3:
displayed.
4: Installation Parameter menu.
5: Key lock indicator.
6: AM or PM for 12h clock hour display.
7: °C or °F unit indicator.
8: Setting temperature or Clock value.
9: Heating demand indication.
10: Pictograms for program creation, program state in
normal operating mode.
11: Program of the current day. (current time bar blinks)
12: RF transmission logo.
13: Open window detection logo.
14: Temporary override function activated
(Timer/booster mode)
2

First Installation

2.1

Batteries installation

- Close the battery cover.
2.2

Time and Date adjustment

Thermostatic Head will automatically require to set Time
and Date. Each time a value blinks, you can adjust it with
the (-) and (+) keys, once the value is chosen, validate it
- Open the battery
cover and insert the
2 AA Alkaline
supplied batteries
(or remove the
small protection
sticker if the
batteries are
already installed in
the compartment).
with the ( ) key. The thermostatic head will jump
automatically to the next value.
Note: You can go back to the previous value by pressing
(◄)
You can go to the next value by pressing (►)
List order of the time and date adjustments (Time & day):
Time 1. Adjustment of the hours
2. Adjustment of the minutes
Date 3. Adjustment of the year
4. Adjustment of the month number (01 to 12)
5. Adjustment of the day number (01 to 31)
Then the blinking message
validate the adjusted time and date.
You can always reach the time and date adjustments by
the clock update mode.
2.3

Thermostatic head installation

Motor Move Menu
Open completely the thermostatic head for an easy
installation
-Go in the Parameters Menu number 10 by pressing and
maintain the ( ) key for more than 5 seconds, and we
will see the following screen :
-Press the ( ) key to validate. You will see
the backlight extinction, the motor will perform the
completely open move (during the move
When the thermostatic head is in the completely open
Open
state, stops blinking and backlight shines again.
You are ready to install the thermostatic head on your
heater.
1
2
1. Heater head
2. Adaptor nut
3. Plastic brackets
4. Fixing Screws
STEP 1
Screw the Adaptor
nut on the heater
3
Save
appears, press ( ) to
Open
Open
3
4
STEP 2
Fix the brackets on the
Adaptor nut and the
thermostatic head
. Wait
blinks).