Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble the top
The table top (1) is shipped with the combination miter-gauge track/
1
T-track (2) in place, but fastened only with a plastic rivet. Remove
the rivet and secure the track with the system screws (3), driving them
into the holes in the table top.
Turn the table top upside down. Align the two support struts (4) with
2
holes in the bottom of the table top. Drive ¾" coarse-thread screws
(5) with the driver bit (6).
ATTENTION
In this step, use the ¾" screws (5), NOT the 1¼"
screws (8).
Position an insert-plate leveler (7) in each corner of the table-top
3
opening. The holes in the levelers align with holes in the table-top.
Fasten the levelers to the tabletop with 1¼" coarse-thread screws (8).
Using the hex wrench (9), drive a set screw (10) into the outside
4
holes in each leveler, threading them in from the bottom until the
tips are ⅜" below the table surface.
Assembly
1
2
5
8
7
10
9
3
4
Publicidad
Tabla de contenido
