M.back Depth Adjustment; N.check-Out - Breezy Elegance Manual De Instrucciones

E NG LIS H
M. BACK DEPTH ADJUSTMENT
IMPORTANT NOTE:
The Back Depth adjustment is intended to compensate for differences in after-market backrest
thickness and/or contour. The back canes can be adjusted about 1" fore and aft relative to the
seat so that the backrest support surface does not change the location of the user, regardless of
the backrest mounting location. This ensures that the center of gravity of the user relative to the
axle location is not altered due to the adjustment for backrest thickness or contour.
1. Back Depth Adjustment
a. Remove the hardware(A) that holds the backrest canes in place and move them forwards
or backwards a maximum of 1".
b. Ensure that the adjustment is exactly the same on both sides of the chair before re-insert-
ing hardware.
c. Re-insert the hardware thru the backrest bracket (B) and frame tube (C) and tighten to
hold the backcanes firmly in place.
N. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories
should also perform smoothly. If you have any problems, follow these procedures.
1. Review the set-up and adjustment section to make sure the chair was set up properly.
2. Review the Troubleshooting table in this section.
3. If your problem persists, contact your dealer or Premium Retailer. If you still have a prob-
lem, contact Sunrise customer service. See the introduction page for details on how to
contact your Premium Retailer or Sunrise customer service.
127071 Rev. A
IX. PREMIUM RETAILER SERVICE & ADJUSTMENT
22
42