Fagor CG6- 20 Instrucciones Generales De Instalación página 30

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Table taps minimum flow adjustment
IMPORTANT: before adjustment, the burner must have fully operating for at least 15 minutes.
b)
For NATURAL GAS and TOWN GAS, turn adjustment screw "F" one way or the other until the flame is
established in the minimum position. For L.P.G. it will be fully tightened (Fig. 5).
Turning the burners on.
a)
Open the main general gas-tap installed on the outside of the appliance.
b)
To ignite the burner, turn the control to the MINIMUM position (Fig. 6, no. 4).
Switching the table burners off.
a)
If it is in any of the MAXIMUM, MINIMUM or intermediate positions, the control must be pressed and
turned clockwise to the OFF position (Fig. 6, no. 2).
Turning the gas oven on.
a)
Using the plate lifting lever will clear the first oven plate in the OP oven. In the rest of the ovens, move the
pilot light ignition access cover.
b)
Press the "P1" push button and at the same time press the pilot piezoelectric "P3" repeatedly, until the
pilot flame lights up. Keep "P1" fully pressed down until the pilot flame is stable when it is released,(Fig.7).
c)
Then onwards, to light the burner, turn the thermostat control "P2" anticlockwise, to the position
corresponding to the chosen temperature (refer to table no. 8).
d)
To assist turning on the oven, a plate lifting plate is included with each cooker to check the proper
functioning of the oven. Their method of use can be observed in the following figure.
Switching the gas oven off.
e)
Turn the thermostat control (Fig. 7) clockwise to the pilot position "PO". In this position, the burner will
switch off, and the pilot will remain on.
f)
To switch the pilot off, press push button "P2" fully in (Fig. 7).
Turning the electric oven on.
g)
Once the heating system has been decided upon (Fig. 8), turn the "MHG" control to the desired position.
The pilot "P2" (Fig.8) (green) will then turn on, indicating that the oven is ready for operation.
h)
Select the temperature according to table no. 10, turning the "MTH" (Fig.8) control to the chosen position.
Pilot "P3" (Fig. 8) (amber) will turn on indicating that the resistors are working.
i)
When the oven reaches the selected temperature, the resistors stop working (by means of the
thermostat) and the "AMBER" pilot "P3" (Fig. 8) will turn off. Additionally, as soon as the selected value
lowers, the resistors will start to work and the "AMBER" pilot will turn on.
Switching off the electric oven.
b)
Take the two "MTH" and "MHG" (Fig. 8) controls to the "OFF" position. The "AMBER" and "VERDE"
pilots turn off (Fig. 8).
2.-USE
29

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cg6- 40Cg6- 41Cge6- 41

Tabla de contenido