Operation - Gardena 9000 aquasensor Manual De Instrucciones

1783-20.960.06_18.08.2011_GARDENA.qxp 06.09.2011 12:03 Seite 14

4. Operation

Automatic operation :
5
Adjust switch-on and
switch-off height :
3
14
2. Only for the submersible pumps Art. No. 1783 / 1785 :
Insert the non-return valve
2
connector with the word UP pointing upwards.
3. Screw the universal fitting
4. Connect the hose to the universal fitting
2
We recommend 38 mm (1 ¹⁄₂ " ) 25 mm (1 " ) hoses, in addition
to be fixed with a GARDENA Hose Clamps Art. No. 7192
z
V
(for 25 mm) and Art. No. 7193 (for 38 mm).
Only for the submersible pumps Art. No. 1783 / 1785 :
For flat suction we recommend using a 13 mm ( ¹⁄₂ " ) or 16 mm
( ⁵⁄₈ " ) hose. The non-return valve
back through the hose. The max. delivery height will only be
achieved without the non-return valve.
Only for 13 mm ( ¹⁄₂ " ) hose :
The universal fitting
Regulator Valve Art. No. 977 so that the contents of the out-
let line do not flow back through the pump after pumping. The
Regulator Valve can be ordered from your GARDENA dealer.
If the water level reaches the ON sensor
matically switches on. Depending on water volume and
6
environment, it can take 1 to 3 minutes until pumping out
commences. As soon as the water level falls below the OFF
4
sensor , the pump is automatically switched off (the pump
continues to run for approx. 10 seconds).
1. Stand the pump on a firm surface
– or –
use a rope attached through the bore hole in the carrying
5
handle to immerse the pump in a well or shaft.
3
2. Plug the power cable
4
The switch-on and switch-off height (see 8. Technical Data) can
be adjusted for automatic mode. The relevant sensor pin defines
the height of the water level.
Set switch-on height ON :
v Push ON sensor
Switch-on height of the pump in automatic mode.
Set switch-off height OFF :
v Push OFF sensor
Switch-off height of the pump in automatic mode.
4
z
supplied into the universal
V
2
onto the pump.
2
z
prevents the water flowing
V
2
can also be equipped with a GARDENA
3
, the pump auto-
6
into a mains socket.
3
to the required switch-on height.
4
to the required switch-off height.
.