Overview - Monacor JTS RU-8011DB/5 Manual De Instrucciones

Diversity UHF Receiver
for a transmitter RU-850... / 5
These instructions are intended for users without
any specific technical knowledge Please read the
instructions carefully prior to operation and keep
them for later reference
The operating elements and connections de-
scribed can be found on page 3
Contents
1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2 Safety Notes . . . . . . . . . . . . . . . . . . . . . . . . . 12
3 Applications . . . . . . . . . . . . . . . . . . . . . . . . . 12
3 .1 Matching transmitters . . . . . . . . . . . . . . . . . . . 12
3 .2 Conformity and approval . . . . . . . . . . . . . . . . . 13
4 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
5 Configuring the System via the Menu . . . . 13
5 .1 Menu section RX (receiver) . . . . . . . . . . . . . . . . 14
5 .1 .1 Selecting a frequency from a group . . . . . . . . 14
5 .1 .2 Setting the frequency directly . . . . . . . . . . . . 14
5 .1 .3 Activating / Deactivating the scan function . . . 14
5 .1 .4 Activating / Deactivating the attenuation
for the XLR output . . . . . . . . . . . . . . . . . . . . . 14
5 .1 .5 Setting the squelch value . . . . . . . . . . . . . . . . 14
5 .2 Menu section TX (transmitter) . . . . . . . . . . . . . . 15
5 .2 .1 Activating / Deactivating the attenuation
for the microphone input . . . . . . . . . . . . . . . . 15
5 .2 .2 Adjusting the audio sensitivity . . . . . . . . . . . . 15
5 .2 .3 Activating automatic switch-off . . . . . . . . . . . 15
5 .2 .4 Adjusting the transmission power . . . . . . . . . 15
5 .2 .5 Configuring the REMOSET function . . . . . . . . 15
6 Adjusting the Volume . . . . . . . . . . . . . . . . . 15
7 Activating / Deactivating the Key Lock . . . . 15
8 Establishing a Transmission Path . . . . . . . . 16
8 .1 Function
(synchronizing receiver and transmitter) . . . . . . 16
9 Specifications . . . . . . . . . . . . . . . . . . . . . . . . 17
9 .1 Groups and channels (frequencies in MHz) . . . . 17

1 Overview

1 Receiving antennas
2 Transmitter section for ultrasonic transmission
3 Button
transmitter via ultrasound:
4 Button to activate /deactivate the key lock
(keep the button pressed for 2 seconds)
5 Display
Indication Meaning
... MHz Radio frequency
G ... CH ... Group number and channel number
RF Strength of the radio signal received
AF Volume of the audio signal received
Diversity indication A or B: to show
which of the antennas receives the
radio signal of the higher quality
Key lock activated
Level of the XLR output (11) attenu-
ATT .ON
ated by 20 dB
Battery symbol: to indicate the battery
status of the transmitter in multiple
levels
The receiver is muted:
- when no radio signal is received or
MUTE
when the radio signal received is poor
- when the transmitter is muted
VOL . ... dB Volume
Note: When the batteries of the transmitter are
almost discharged, the display backlight will change
to red and the battery symbol will start flashing
6 Buttons and
 
Within the menu: to change a setting
Outside of the menu: to adjust the volume
7 Button SET to call up the menu (fig 1 on
page 2): keep the button pressed for 2 seconds
Within the menu: to select the menu items
and to save a changed setting
8 Power switch
9 BNC jacks for the two antennas (1) provided
10 Audio output (6 3 mm jack, unbalanced) for
connection to an input with line signal level
11 Audio output (XLR, balanced) for connection
to an input with line signal level or, when
to transfer settings to the
☞ chapter 8 1
11