Exo Terra Monsoon RS400 Manual De Instrucciones página 3

• A "drip loop" shown in the figure
beside, should be arranged by the
user for each cord connecting a
power adaptor to the socket. The
"drip loop" is the part of the cord
below the level of the receptacle,
or the connector if an extension cord
is in use. This prevents water from
traveling along the cord and coming
into contact with the socket or power supply. If the plug or socket
gets wet, DO NOT unplug the cord. Disconnect the fuse or circuit
breaker that supplies power to the appliance then unplug and
examine for the presence of water in the socket.
• To avoid injury, do not contact moving or hot parts such as lamps,
heaters, reflectors or bulbs.
• CAUTION - Always unplug or disconnect the appliance from
the outlet before putting on or taking off parts and while the
equipment is being installed, maintained or handled. Never yank
the cord to pull the power adaptor from the outlet. Grasp the
power adaptor body and pull to disconnect. Always unplug an
appliance from an outlet when not in use. Never lift this product
by the supply cord.
• This appliance is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities,
or lack of experience or knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
4
• Do not use this appliance for other than its intended use. The
use of attachments not recommended or sold by the appliance
manufacturer may cause an unsafe condition.
• Do not install or store the appliance where it will be exposed to
temperatures below freezing. Do not expose the unit to direct
sunlight.
• Ensure that the appliance is placed on a flat, even surface.
Monitor the product regularly. Do not leave the product unattended
for extended periods.
• If an extension cord is necessary, ensure the connection is
watertight and dust proof. A cord with a proper rating should be
used. A cord rated for less amperes or watts than the appliance
rating may overheat. Care should be taken to arrange the cord so
that it will not be tripped over or pulled. The connection should be
carried out by a qualified electrical installer.
• Indoor Household Use Only. Not for commercial use.
• CAUTION - To prevent corrosion or deterioration of materials that
could lead to electric shock, use only with fresh water.
• Do not add any chemicals or medicinal compounds to the water
used in this device.
• IMPORTANT - Pump must not be allowed to run dry.
SAVE THESE INSTRUCTIONS.
Installation - Exo Terra Natural Terrariums
Follow this installation procedure to install the Exo Terra
RS400 system on any size of Exo Terra
system comes with two nozzles, which should be mounted on either
glass side panel of the terrarium as close as possible to the opening
A
1. Unlock the top screen cover and lift it off the terrarium.
2. Slide the inlet holes (located on the back of the screen top on
either side) to the open position, so the tubing will fit through.
3. Feed the tubing through the first inlet hole on each side on the
back of the screen cover. (fig. A)
B
4. Mount the nozzles in position on the glass portion of the
terrarium's side panels with the suction cups. Make sure that
the glass area is clean and free of any dirt or deposits before
mounting the nozzles. For the best results, mount the nozzles
as close as possible to the front opening windows and the top
screen. (fig. B)
5. Direct the nozzle positions inside the terrarium so that the spray
stream will avoid spraying on the terrarium's front and side
panels when in operation.
6. Use the additional suction cups to neatly guide the tubing along
the side panels to the inlets at the back of the terrarium.
7. Replace the top screen cover and lock it back into position.
® Monsoon
Natural Terrarium. The
®