SilverCrest SIRD 14 C3
Software update
This menu allows you to adjust software update settings.
[Auto-check setting] This option automatically checks for new updates from time to time.
Automatic updating is enabled by default. To disable it, select "NO". To enable it again, select
"YES".
[Check now] Use this option to search for available updates immediately.
If an update is available, it is shown on the display [1]. Follow the instructions on the display [1].
Do not power the device off or disconnect it from the mains during the update! This
could result in a complete device failure.
Setup wizard
With this function, you can start the setup wizard at any time. Any parameters or stations entered
already are not deleted. For more information, please read the „First-time setup" chapter on page
70.
Info
This menu item shows the software version (SW version), Radio ID and Friendly Name (model
name) of your Internet Radio.
Backlight
You can change the display brightness settings here.
[Timeout] This lets you set the timeout after which the display [1] is dimmed in standby mode.
Selecting "ON" keeps the display backlight switched on in standby mode.
[Power-on Level] This lets you set the display [1] brightness to "High", "Medium" or "Low".
Ambient Light
This lets you set the illumination of the NAVIGATE knob [3] and the VOLUME knob [9] as follows:
High, Medium, Low or Off.
The
icon indicates the current setting.
Multi-room
You can use your Internet Radio as a speaker of a multi-room audio system. This menu lets you
query the status and other information of the Internet Radio in your multi-room system as well as
100 - English