Petromax HK150 Manual De Instrucciones página 14

Using the lamp
DE
Prior to starting the lamp
EN
• Damaged mantles must be replaced immediately.
FR
• Make sure that needle, spray nozzle, mixing chamber, and burner are properly tightened and connected.
Starting the lamp
ES
• See "Starting: Step by Step."
TW
After starting the lamp
RU
• When the pressure falls below 1 bar, carefully add pressure to the tank using the hand pump (approx.
2.5 bar).
KR
Extinguishing the lamp
JP
• To extinguish the lamp, release the pressure via the bleeder screw.
• In the case of unpredicted flames development, open the bleeder screw immediately.
FI
• Finish by turning the handwheel upward.
SE
Troubleshooting
The pump does not work properly.
Pull out the pump plunger, grease the leather seal and gently widen the leather seal (replace it if
necessary!). Push the pump plunger back into the cylinder of the pump by turning the pump plunger.
The upper part of the lamp catches fire.
Preheat the lamp for at least 90 seconds using the rapid preheater. When pre-heating with the use of
spirit (preheat cup), use at least two full cups of spirit.
The incandescent mantle does not burn properly.
When using the rapid preheater, position the incandescent mantle in a way that it can easily catch fire
via the rapid preheater.
The rapid preheater does not ignite/burn properly.
Ensure that there is neither to much nor too little pressure in the tank. The manometer needle should
be just below the red line! If necessary, clean the nozzle of the rapid preheater with the cleaning needle
included in the replacement parts set.
The light flickers or gets darker.
Make sure that there is enough pressure and fuel in the tank. If necessary, rapidly turn the handwheel
360 degrees to free the spray nozzle of any particles via the needle.
14