Troubleshooting; Before You Do Troubleshooting; Troubleshooting Table; Repairs - Gardena ComfortCut 550/50 Manual De Instrucciones

Before you do troubleshooting

WARNING!
• Risc of physical injury!
• Cut injury when the product starts
accidentally.
• Disconnect the product from the mains
and slid the protective cover over the
blade before you do troubleshooting .

Troubleshooting table

Problem
Product does not start.
Product can no longer be stopped. Start button is stuck.
Hedge is not cleanly cut.

Repairs

Note:
For any other malfunctions please contact the GARDENA
service department. Repairs must only be done by
GARDENA service departments or specialist dealers
approved by GARDENA .

Electric Hedge Trimmer

Rated Power:
Mains voltage:
Mains frequency:
Strokes:
Length of blade:
Tooth gap of blade:
Weight:
20

Troubleshooting

Possible Cause
Extention cable is disconnected or da-
maged
Blade is blocked.
Blade is blunt or damaged.

Technical data

Unit Value (Art. 9833 )
W 550
V 230
Hz 50
1/min. 3400
cm 50
mm 27
kg 3,6
Remedy
Connect the extension cable or if ne-
cessary replace it.
Remove the obstacle.
Disconnect the mains and loosen the
start button.
Have blade replaced by GARDENA
Service.
Value (Art. 9834 ) Value (Art. 9835 )
600 700
230 230
50 50
3400 3400
55 65
27 27
3,7 3,9
15 - 002 - 30.09.2016