Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4
4.7
Notes
•
Do not touch the antenna while transmitting, it could affect the
range.
•
Remove the batteries if the device is not going to be used for a long
period.
5
Cleaning and maintenance
•
To clean the unit, wipe with a soft cloth dampened with water. Don't
use a cleaner or solvents on the unit; they can damage the case and
leak inside, causing permanent damage.
•
Battery contacts may be wiped with a dry lint-free cloth.
•
If the unit gets wet, turn it off and remove the batteries immediately.
Dry the battery compartment with a soft cloth to minimize potential
water damage. Leave the cover off the battery compartment
overnight or until completely dry. Do not use the unit until completely
dry.
6
Disposal of the device (environment)
At the end of the product lifecycle, you should not throw this
product into the normal household garbage but bring the
product to a collection point for the recycling of electrical
and electronic equipments. The symbol on the product,
user guide and/or box indicate this.
Some of the product materials can be re-used if you bring
them to a recycling point. By re-using some parts or raw materials from
used products you make an important contribution to the protection of the
environment. Please contact your local authorities in case you need more
information on the collection points in your area.
7
Using a PMR device
To communicate between PMR devices they need to be set all on the
same channel and CTCSS/DCS code (see chapter "13.7 CTCSS
(Continious Tone Coded Squelch System) / DCS (Digital Coded
Squelch)" and within receiving range (up to max. 10 km in open field).
Since these devices use free frequency bands (channels), all devices in
operation share these channels(total 8 channels). Therefore, privacy is
not garanteed. Anybody with a PMR set to your channel can overhear the
conversation. If you want to communicate (transmitting a voice signal)
you need to press the
PTT
-button
12
.
Once this button pressed, the device will go into transmit mode and you
can speak into the microphone. All other PMR devices in range , on the
same channel and in standby mode (not transmitting) will hear your
message. You need to wait until the other party stops transmitting before
you can reply to the message. At the end of each transmission the unit
will send a beep if the Roger Beep is enable (see chapter "13.12 Roger
Beep On/Off" ). To reply, just press the
the microphone.
If 2 or more users press the
time the receiver will receive only the stongest signal
and the other signal(s) will be supressed. Therefore you
should only transmit a signal (press
when the channel is free.
The range of radio waves is strongly affected by
obstacles such as buildings, concrete/metal structures,
the unevenness of the landscape, woodland, plants, ...
This implies that the range between two or more PMR's
may in some extreme cases be restricted to a maximum
of a few tens of meters. You will soon notice that PMR
works best when there is a minimum of obstacles
between users.
8
Included in the package
•
1 x Twintalker 9500 Airsoft Edition
•
1 x Power adapter
•
4 x AAA NiMh batteries
•
Headset
•
User guide
Twintalker 9500 Airsoft Edition
12
PTT
-button
and speak into
12
PTT
- button
at the same
12
PTT
- button
)
Publicidad
Tabla de contenido
