Call Tones; Roger Beep On/Off; Key-Tone On/Off - Topcom Twintalker 9500 Airsoft Manual De Usuario

Twintalker 9500 Airsoft Edition
13.10.3 Scanning for a DCS code
• Press the
"SCAN" and "DCS 00" flashes on the
display for the selected radio channel.
• Press the
button
Once there is a transmission on the channel, the DCS code (if used) will
be detected and displayed.
If you press the PTT
found DCS code, the PMR will go back in stand-by mode
on the channel with the DCS code.

13.11 Call Tones

A call tone alerts others that you want to start talking.
13.11.1 Setting the Call Tone
The Twintalker 9500 has 15 call tones.
• Press the
"C" is displayed and the current call tone
is flashing.
• Press the
button
Tone.
• Press the
and return to stand-by mode.
13.11.2 Sending a call Tone
6
Press the button briefly. The call tone will be transmitted on the
set channel.
13.11.3 Call tone reception type
7
• Press the -button nine times.
11
• Press the -button or
reception type.
7
-button seven times :
11
-button or the -
10
to start the DCS scan.
12
button while listening to a
7
- button eight times,
11
- button or the -
10
to change to another Call
12
PTT
- button to confirm
10
-button to select the call tone
1. Tone only
2. Tone + vibration
3. Vibration only
12
Press the PTT -button to confirm and return to stand-by mode.

13.12 Roger Beep On/Off

12
After the PTT -button is released, the unit will send out a roger beep
to confirm that you have stopped talking.
To set the Roger Beep.
•Press the
displayed.
•Press
10
button
•Press the
selection and return to the

13.13 Key-Tone On/Off

When a button is pressed, the unit will beep briefly.
To set the key-tone.
•Press
displayed.
•Press
10
button
•Press the
selection and return to the standby mode.
13.14 Dual Channel Monitor function
In stand-by, the PMR is set on one channel with CTCSS/DCS code. The
PMR will only receive signals transmitted on that channel with the
CTCSS/DCS code.
7
- button ten times. 'rO' will be
11
button to enable (ON) or
to disable the Roger-Beep (OFF).
12
PTT
- button to confirm your
standby mode.
7
button eleven times. 'tO' will be
11
button to enable (ON) or
to disable the Key Tones (OFF).
12
PTT
- button to confirm your
9