Change Illuminant; Install The Work Lamp - brennenstuhl Power Jet-Light 2 x 36 W Instrucciones De Uso

Power Jet-Light 2 x 36 W IP 54
6.2

Change Illuminant

DANGER:
Pull the mains plug before opening the work lamp!
Let the work lamp cool before contact (at least 15 minutes). Contact can lead to burns.
Step Activity
1 Set the work lamp on its back. Press the rubber lip in the corner towards the bottom.
2 Pull the protective cover from the corner.
3 Press the bolt downwards. Pull the illuminant from the socket.
17
4 Insert the new illuminant with gentle pressure. The bolt locks in place and holds the
illuminant firm even during rough handling
5 Install the protective cover. For this purpose, press the rubber lip downwards and insert the
protective cover. Note the correct position of the seal between the casing and the protective
cover.
6.3

Install the work lamp

There are two possibilities of installing the work lamp
1. Possibility : In metal stands
Operating Manual
Pos.
4
4
8
8
Pos.
5
5
7
17
7
2. Possibility: without metal stands
15
Name
Protective cover
Rubber lip
Name
Illuminant
Socket
Bolt
Status: 7201S-07-2007_K