Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador página 60

EN IT
14
DISPLAY POSSIBLE CAUSE
Sensing edge COS1 not connected or
incorrectly connected.
Sensing edge COS2 not connected or
incorrectly connected.
rectly connected.
rectly connected.
tact state or not connected.
incorrectly connected.
incorrectly connected.
nected or incorrectly connected.
Or LEAF 1 is open.
nected or incorrectly connected.
Or LEAF 1 is closed.
nected or incorrectly connected.
Or LEAF 2 is open.
nected.
Or LEAF 2 is closed.
nected.
N.B.: Press TEST
60 60
STOP contact is open.
FT1 not connected or incor
FT2 not connected or incor
TEST Mode.
used or to disable.
used or to disable.
e
e
PHYSICAL CORRECTIVE ACTION
Install a STOP
COM contact.
Jumper contact COS1
used or to disable
Jumper contact COS2
used or to disable.
Jumper contact FT1
Jumper contact FT2
PP COM
CH COM
AP COM
PED COM
ORO COM contacts. Contact must not be
ST con
COM
COM
COM
COM