Arming Buzzer; Installation Check Mode - Toyota VSS 1 Manual Del Propietário

This mode has to be manually activated by following this procedure:
1. Disarm by remote control.
2. Insert the key into the ignition and turn to IG ON.
3. Open and close the door 7 times within 30 seconds.
4. Turn the key to IG OFF.
The hazards will flash once (confirmation).
After 5 engine starts, the garage mode will be cancelled. The hazards will turn on twice.

2.8 Arming buzzer

This option is disabled as default. To enable it, please contact your authorised retailer.
You can activate the buzzer to sound when you arm/disarm the system.
Remark:
– This can only be done in accordance with local regulations.

2.9. Installation check mode

The system can confirm correct installation or if a sensor is not working correctly.
If you suspect that a sensor is not working correctly, please contact your authorised retailer.
12 VSS1