Arm Without Intrusion Sensor - Toyota VSS 1 Manual Del Propietário

1.5 Arm without intrusion sensor

If you have to lock the car with somebody inside (passenger, children, dog, ...), you must
deactivate the Intrusion Sensor.
Central Door Lock
(Located on the driver's door)
Activation steps
1 Open the driver's
door.
2 Operate the Central
Power Door Lock
switch to the
lock and unlock
positions 3 times
with the driver's
door open (interval
between each press
should be less than
5 seconds).
3 Close all doors,
bonnet and boot,
then lock the car
by remote control
or smart key within
5 minutes.
NOTE:
– The interior sensor is deactivated for 1 use only. On the next arming the interior sensor will be
activated again.
8 VSS1
Unlock
Hazard light
indication
–
–
Flashes once.
Lock
Alarm status
light (LED)
–
LED indication
will flash rapidly
for 5 minutes, or
until you arm the
system.
ON for 30 seconds,
then start flashing.
Buzzer
–
2 beeps sound
when the sensors
are deactivated.
–