Operation; 1 Navigating Through The Menu; 2 Independent Operation - IMG STAGELINE ODP-120/6COL Manual De Instrucciones

4 Operation

4.1 Navigating through the menu

The operating modes and the setting functions
are selected via a menu (refer to Fig . 17 on page
78) by means of the control buttons:
Button Function
to call up the main menu level from the start
display
to call up a submenu item
ENTER
to activate a menu item to change a setting
to save a setting
UP to go to the next menu item / to increase a value
DOWN to go to the previous menu item / to reduce a value
MENU to return to the higher menu level
Fig. 3 Control buttons
After the spotlight is switched on, the display
will show the DMX start address in large figures
(start display), e . g .:
•
DMX temp: 028
DMX Address
001
Key lock open
From this start display, press the button ENTER:
The main menu level with the following menu
items is called up . To select the main menu
items, use the buttons UP and DOWN .
Menu item Function
to set the DMX start address and
DMX
the number of DMX channels
to select the basic function:
RUN MODE
DMX mode and master unit or slave unit
SET UP to make basic settings
display of
software version
INFORMATION
hardware version
operating hours
to select automatic light shows (01 – 21)
AUTO
and speed
CUSTOMER to run user-defined light shows
to call up 11 shades of white or to overwrite
CAL WHITE
the shades with user-defined values
STAT COLO independent colour spotlight mode
EDIT to create user-defined light shows
16
Fig. 4 Start display
Menu item Function
to transfer user-defined light shows to
UPLOAD
slave units
RESET to reset the spotlight to its factory settings
Fig. 5 Main menu items
The operating modes are highlighted in light
grey .

4.2 Independent operation

When the spotlight is operated independently,
the following modes are available:
1 . Execution of 21 fixed light show programs
via the menu item [AUTO]
2 . Execution of 11 user-defined light show pro-
grams via the menu item [CUSTOMER]
3 . Selection of 11 predefined shades of white
via the menu item [CAL WHITE]; user-defined
settings are possible
4 . Setting of any colour desired via the menu
item [STAT COLO] and selection of 31 fixed
colours via the submenu item [SELECT
COLOR]
[AUTO] Light show programs 01 to 21
1) After selecting this menu item, press the
button ENTER . The display will show either
[AUTO MODE] and the show program num-
ber or [SPEED] and the value of the program
speed .
2) Use the buttons UP and DOWN to switch
between [AUTO MODE] and [SPEED] .
3) To set a show program or the program speed,
select the corresponding menu item and
press the button ENTER . Use the buttons UP
and DOWN to make the settings and press
the button ENTER to confirm .
4) To select a different operating mode, press
the button MENU to return to the main menu
level .
[CUSTOMER] User-defined programs
1) After selecting this menu item, press the but-
ton ENTER . The display will show the current
program number .
2) To select a different show program, press
the button ENTER, use the buttons UP and
DOWN to select the program and press the
button ENTER to confirm .
Note: For creating programs refer to chapter 4 .2 .2 .