Tribest Sedona Express SD-6780 Manual De Instrucciones página 12

3) When the TIMER window flashes, set the desired hours by using the 10 or 1 buttons to select the
desired number of hours; then press the SET button after you have set the timer and finalize your
choice.
• When SET button is pressed during operation, it enables you to turn on the LED light inside of
the dehydration compartment for easy monitoring and observation. The LED light will turn on for
10 seconds before automatically turning OFF.
NOTE:
• You may set the dehydrating time for up to 99 hours.
• The Sedona Express has a Continuous Operation function, which allows you to continuously
dehydrate for more than 99 hours. To enable this function, press and hold the 10 up button until
CO is displayed.
• The CO function will allow dehydrator to operate for a maximum of 120 hours.
• The default setting for Fast Mode: 167°F (75°C) for 1 hour.
• The default setting for Raw Mode: 113°F (45°C) for 10 hours.
• The Sedona Express will save your settings for the next use even when you turn off the dehydrator.
4. UP/DOWN (10,1) buttons are for setting the temperature or the hours for the timer - one short
press will change the number by 10 or 1, and when the button is pressed for more than 1
second the number will continuously increase or decrease at a rapid pace.
5. TEMP display shows the set temperature:
• During set-up, this window displays the user's desired temperature of the drying chamber.
NOTE: The temperature of the drying chamber is regulated by a thermal sensor. The actual tem-
perature of the drying chamber may be affected by changes in the temperature and humidity of the
inflowing air, which may result in slight temperature fluctuations.
NOTE: While the temperature displayed by the TEMP Display is the set desired temperature, actual
temperatures in the drying chamber may fluctuate up to ±5°C (±9°F)
6. TIMER display shows the total number of hours set for each desired temperature. This timer
automatically counts down, showing the hours remaining for dehydration.
7. F/°C button will enable you to select a temperature display mode (Fahrenheit or Celsius).
NOTE: The default setting of the Sedona Express is in Celsius (°C). Once you set the machine
to Celsius or Fahrenheit, the Sedona Express will remember your setting even after you turn the
unit off.
8. START/PAUSE button starts, pauses, or restarts the operation.
NOTE:
• While the Tribest Sedona Express is in operation, if you open the door the power
supply to both the heating coil and the fan will be shut-off. The Tribest Sedona Express will
automatically restart as soon as the door is closed.
• You will hear a beep when the buttons are pressed, when the door is opened, and when the
assigned time is over.
• To change the temperature and/or operation hours when the Sedona Express is running, press
the START/PAUSE button, then press the SET button and change the temperature and/or time.
Then press the START/PAUSE button to restart the Sedona Express.
• Two green-lit dots will blink on the bottom right-hand side of the set temperature display and
set timer display, once the START/PAUSE button is pressed and the unit is turned on.
- The dot next to the temperature display will only blink when the heating mechanism is
activated. When the temperature inside the drying chamber reaches the set temperature,
12