Genesis GSS160 Manual Del Operario página 14

LUBRICATION (Fig 12)
Lubricate the arm bearings after 10 hours of use. Re-oil after
every 50 hours of use or whenever there is a squeak coming
from the bearing.
To Lubricate:
1. Remove the two rubber bearing covers on one side.
2. Turn the saw on it side.
3. Squirt a generous amount of SAe 20 oil around the shaft
end and bronze bearing.
4. Let the oil soak in overnight in this condition.
5. Next day repeat the above procedure for the opposite side
of the saw.
16" Variable Speed Scroll Saw
Operator's Manual
Fig 12
GSS160