Genesis GSS160 Manual Del Operario página 8

Sierra de calar de 16”, de velocidad variable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

UnPACKing AnD COnTEnT
iMPOrTAnT:
unlikely the tool is faulty or that a part is missing. if you find anything
wrong, do not operate the tool until the parts have been replaced or the
fault has been rectified. Failure to do so could result in serious personal
injury.
2
Contents in Package: (Fig 2)
item Description
Scroll Saw
Pin end Blade (1)
Dust Blower Tube (2)
Rubber foot & Hardware(3) 3
Blade Clamp Screws (7)
WArning:
assemble the saw, plug in power cord or turn the switch on until the missing or
damaged parts are replaced.
ASSEMBLY
WArning:
from the power source before adjusting, adding accessories, or checking a
function on the tool.
Installing the Sawdust Blower (FIG 3)
Connect the flexible dust blower tube (1) hand tight into
the blower outlet (2) on top of the saw arm by turning it
clockwise. Do not over-tighten the flexible dust blower tube.
for best results, the dust blower tube (1) should be
adjusted to direct air at both the blade and the work piece.
16" Variable Speed Scroll Saw
Operator's Manual
Due to modern mass production techniques, it is
3
6
1
QTY
1
Clear Shield (4)
2
Shield Installation Knob (5)
1
Allen Wrench (6)
Operator's Manual (Not shown)
2
if any parts are missing or damaged, do not attempt to
Always be sure that the tool is switched off and unplugged
5
7
item Description
Fig 3
GSS160
4
FIG 2
QTY
1
2
1
1
1
2

Publicidad

Tabla de contenido
loading

Tabla de contenido