Potential Balance; Operating Guidelines; Accessories; Scope Of Supply - Cooper Hand Tools Weller WD 1 Manual De Uso

update, whereby the control unit can be provided with the
most up-to-date operating software.
The monitor software can be used for remote control of the
unit. Temperature curves can also be presented graphically,
printed out and saved.

6. Potential balance

Due to the different circuits in the 3.5 mm switch jack sok-
ket (8), 4 variations are possible:
Hard-earthed: without plug
(delivery status)
Potential balance: with plug, balance line at middle
(Impedance 0 Ohm) contact
Potential-free: with plug
Soft-earthed: with plug and soldered resistor.
Earthing via selected resistance
value.

7. Operating guidelines

During the first heating-up period, coat the selected tinnable
soldering tip with solder. This removes oxide layers and con-
tamination on the soldering tip caused by storage. Never use
an aggressive flux.
The transition between heating element/sensor and the sol-
dering tip must not be impaired by dirt, foreign bodies or
damage because this would affect the accuracy of the tem-
perature control.
Handling the soldering tips
●
Select as low a working temperature as possible
●
Select the largest possible soldering tip form for the
application.
Rule of thumb soldering tip: approx. as big as the solde-
ring pad
●
Guarantee a large-surface heat carriage between solde-
ring tip and solder joint by properly tin-plating the solde-
ring tip.
●
Before long work breaks, switch the soldering system
off, or use the Weller function for temperature decrease
when not in use.
●
Coat the tip before placing the soldering iron in the rest.
●
Apply solder directly to the solder joint and not on the
soldering tip.
●
Use the corresponding tool to change the soldering tips.
●
Never apply mechanical force to the soldering tip.

8. Accessories

005 13 173 99 WMRP soldering iron handpiece
(without soldering tip)
005 13 825 99 Spiral wool
005 15 121 99 WDH 10T Schaltablage
WSP 80/WP 80
005 15 122 99 WDH 20T Schaltablage für WMP
005 15 125 99 Dry cleaning insert WDC 2
005 27 028 99 Pre-heating plate WHP 80
005 29 178 99 Soldering iron set WSP 80
005 29 179 99 Desoldering set WTA 50
005 31 185 99 USB Extension module
005 33 113 99 Soldering iron set LR 82
005 33 131 99 Soldering iron set MPR 80
005 33 133 99 Soldering iron set WMP
WMRH WMRH soldering iron holder for
WMRP
WMRP WMRT desoldering set

9. Scope of supply

WD 1000
Control unit
Mains cable
Jack plug
Soldering iron
Safety rest
Operating Instructions
Safety Information
WD 1000M
Control unit
Mains cable
Jack plug
Soldering iron
Safety rest
Safety Information (CD)
Operating Instructions (CD)
USB cable
Soldering tips 161-165
Exploded drawing WD 1, see page 168
Circuit diagram WD 1, see page 169
Exploded drawing WD 1M, see page 170
Circuit diagram WD 1M, see page 171
Subject to technical alterations and amendments!
English
WD 1
Control unit
Mains cable
Jack plug
Operating
Instructions
Safety Information
WD 1M
Control unit
Mains cable
Jack plug
Safety Information (CD)
Operating Instructions
(CD)
USB cable
40