Saving, Displaying And Deleting Measurements; Error Message/Trouble Shooting - Beurer BM 47 Manual De Instrucciones

ments can be classified and assessed according to the
following table.
However, these standard values serve only as a general
guideline, as the individual blood pressure varies in different
people and different age groups etc.
It is important to consult your doctor regularly for advice.
Your doctor will tell you your individual values for normal
blood pressure as well as the value above which your blood
pressure is classified as dangerous.
The bar chart on the display and the scale on the unit show
which category the recorded BMI values fall into.
If the values of systole and diastole fall into two different
WHO categories (e.g. systole in the 'High normal' category
and diastole in the 'Normal' category), the graphical WHO
classification on the unit always shows the higher category;
for the example given this would be 'High normal'.
7. Saving, displaying and deleting
measurements
• The results of every successful measurement are stored
together with the date and time. If there are more than
30 measurements, the oldest measurements are lost.
• Press the - or + function button. Select the desired user
memory ( ... ) by pressing the -/+ function button.
Confirm your selection with the START/STOP button
• If you press the memory button M, the average value of
all the stored measured values in the user memory will be
displayed. If you press the memory button M again, the
average value of the morning measurements for the last 7
days will be displayed. (morning: 5.00 – 9.00, display
If you press the memory button M again, the average
value of the evening measurements for the last 7 days will
be displayed. (evening: 18.00 – 20.00, display
continue to press the memory button M, the most recent
individual measured values are displayed in turn with the
date and time.
• You can delete the memory by pressing and holding the
memory button M for 3 seconds.
• To switch off, press the START/STOP button
• If you forget to switch off the unit, it will switch off auto-
matically after 1 minute.

8. Error message/trouble shooting

In the event of errors, the error message
display.
Error messages may appear if:
• systolic or diastolic pressure could not be measured (
or appears on the display)
• systolic or diastolic pressure was outside the measure-
ment range ( or Lo appears on the display)
• the cuff is fastened too tightly or loosely (
appears on the display)
.
• the pump pressure is higher than 300 mmHg (
appears on the display)
23
).
). If you
.
_ appears on the
or