Worx Landroid WG794 Manual Del Usuario página 10

Installation
Pegging your boundary wire
We recommend that you first mow the lawn where the wire is to be laid using a normal lawn mower or a
grass trimmer. This ensures that the wire is laid as close to the ground as possible so the Landroid
accidentally cut the wire. The boundary wire is powered with a very low voltage so that it is totally safe to human
beings and pets.
10
EN
1
Place the Charging Base in its designated spot, without fixing it
permanently. The "IN" arrow should be oriented so that it indicates
the inside of your lawn.
2
Feed the boundary wire through the tunnel underneath the
charging base.
3
Leaving about 3 ft in length of extra wire, start from the rear
of your charging base and begin pegging the wire along the
boundary. When you've finished laying the wire along the
boundary back to the charging base, leave another meter of
extra wire and then cut it.
M does not
®